Register
Why is an endmill better suited for cutting grooves than other cutters? A) Endmills have a larger cutting diameter. B) Endmills have straight teeth for efficient cutting. C) Endmills have a greater number
149k views
2 votes
Why is an endmill better suited for cutting grooves than other cutters? A) Endmills have a larger cutting diameter. B) Endmills have straight teeth for efficient cutting. C) Endmills have a greater number of flutes for improved chip evacuation. D) Endmills have a tapered shape for precise corner cutting.

User Lukas
by
7.6k points

1 Answer

3 votes

Final answer:

Endmills are better suited for cutting grooves due to their straight teeth, greater number of flutes, and tapered shape.

Step-by-step explanation:

An endmill is better suited for cutting grooves than other cutters due to its straight teeth, greater number of flutes, and tapered shape.

  1. Straight teeth: Endmills have straight teeth that enable efficient cutting by providing a continuous cutting edge.
  2. Greater number of flutes: Endmills typically have more flutes, or cutting edges, which helps in improved chip evacuation, reducing the chance of clogging.
  3. Tapered shape: The tapered shape of endmills allows for precise corner cutting, making them ideal for creating grooves.

Learn more about Endmills

User Obicere
by
8.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!