Register
A circuit consists of five unequal loads connected in parallel. To measure the resistance through one specific load, you must. A. Remove power from the circuit and measure the load's resistance in its
210k views
4 votes
A circuit consists of five unequal loads connected in parallel. To measure the resistance through one specific load, you must.

A. Remove power from the circuit and measure the load's resistance in its installed location.
B. apply power to the circuit, disconnect the load from the circuit, and measure the load's resistance.
C. Remove power from the circuit disconnect the load from the circuit, and measure the load's resistance
D. apply power to the circuit, measure the overall circuit resistance, and divide this value by five.

User Anukool
by
8.7k points

1 Answer

6 votes
The correct answer is B. apply power to the circuit, disconnect the load from the circuit, and measure the load's resistance. This is because when the load is disconnected from the circuit, you can directly measure its resistance without the interference of other loads connected in parallel.
User Sakthisundar
by
7.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Where are all the controls on most circuits?
Link Copied!