Register
There may be more than one correct answer. Select all that apply. Which tool(s) is necessary to measure the flatness of engine components? Caliper Micrometer Straight Edge Feeler Gauge Telescopic Gauge
234k views
0 votes
There may be more than one correct answer. Select all that apply.

Which tool(s) is necessary to measure the flatness of engine components?
Caliper Micrometer
Straight Edge
Feeler Gauge
Telescopic Gauge

User Rafal Spacjer
by
7.2k points

1 Answer

4 votes

Final answer:

The tools necessary to measure the flatness of engine components are the Caliper Micrometer, Straight Edge, and Feeler Gauge.


Step-by-step explanation:

The tools necessary to measure the flatness of engine components include the Caliper Micrometer, Straight Edge, and Feeler Gauge.

The Caliper Micrometer is used to measure the thickness or diameter of an object with high accuracy.

The Straight Edge is a precision flat tool that is placed on the engine component to identify any irregularities or deviations from flatness.

The Feeler Gauge is used to measure the clearance or gap between two surfaces to determine the flatness of engine components.


Learn more about Measuring flatness of engine components

User SystemRaen
by
7.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!