Register
in assembly language......not c Attach the ULN2003 driver board to the ATmega328 Xplained board. The four leads of the driver board IN1 - IN4 are controlled by four pins PB.0 - PB.3. Ground is connected
199k views
3 votes
in assembly language......not c Attach the ULN2003 driver board to the ATmega328 Xplained board. The four leads of the driver board IN1 - IN4 are controlled by four pins PB.0 - PB.3. Ground is connected to - input and 5V is connected to the + pin. Use the LED outputs to verify to outputs before connecting the motor. IN1 IN2 IN3 IN4 X113647 28BYJ-48 Stepper Motor Driver. C. D'Arcy 2019. PERPRSE 10 38 68 E ULN2003 1C 3C 4C 5C 6C 7C COM 1uF Tantalum 25V 5-12V 860 - + Jumper 1X5 Optional Jumper A 3mm R1 470 wwwwww R2 R3 R4

User Mmalmeida
by
8.0k points

1 Answer

0 votes

Final answer:

The question is about connecting a ULN2003 driver board to an ATmega328 Xplained board for controlling a 28BYJ-48 Stepper Motor. This involves connecting the input leads to the corresponding ATmega board pins, connecting the correct power supplies, and verifying outputs using the built-in LEDs on the driver board.

Step-by-step explanation:

Based on the information provided, it appears you're trying to connect a ULN2003 driver board to the ATmega328 Xplained board to control a 28BYJ-48 Stepper Motor. Start by connecting the four input leads (IN1 - IN4) to the corresponding pins on the ATmega board (PB.0 - PB.3). Connect the ground (-) to the ground input usually denoted by '-' and the 5V power supply to ‘+’ pin. Upon successful connection, you should use the LED outputs on ULN2003 to verify if they're functioning properly before attempting to connect the motor. The LEDs will provide immediate visual feedback on the status of the outputs.

Learn more about Connecting a ULN2003 driver board

User FirstDivision
by
7.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.5m questions

11.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!