Register
Live display tanks for molluscan shellfish require a: 1. Variance from the regulatory authority and a HACCP plan 2. Water filtration feature and a self-cleaning tank system 3. Cooling device to keep the
71.1k views
5 votes
Live display tanks for molluscan shellfish require a: 1. Variance from the regulatory authority and a HACCP plan 2. Water filtration feature and a self-cleaning tank system 3. Cooling device to keep the water temperature below 41 F (5 C) 4. Liquid waste drain lane equipped with an air gap to defeat back-flow

User AZorin
by
6.6k points

1 Answer

1 vote

Final answer:

A live display tank for molluscan shellfish would typically require a HACCP plan, variance from a regulatory authority, a water filtration system, a cooling device to control water temperature, and a liquid waste drain lane with an air gap to prevent backflow.

Step-by-step explanation:

The topic about live display tanks for molluscan shellfish borders on various aspects of shellfish biology and aquaculture practices. Among the options provided, a proper live display tank would ideally require a HACCP plan (Hazard Analysis Critical Control Point) and a variance from a regulatory authority to ensure the safety and quality of the shellfish being displayed. Additionally, because shellfish are aquatic organisms, features such as a water filtration system and a device to regulate the water temperature (ideally below 41 F / 5 C) are essential. Finally, to prevent contamination from the backflow of waste water, a liquid waste drain lane equipped with an air gap could also be beneficial. The exact requirements may vary depending on the specific species of molluscan shellfish and local regulations.

Learn more about Molluscan Shellfish Live Display Tanks

User John Durand
by
7.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.0m questions

10.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!