Register

The use of a center line plus diameter symbol indicates that the part is? A. Cubed B. Flat C. Uneven D. Cylindrical

The use of a center line plus diameter symbol indicates that the part is? A. Cubed B. Flat C. Uneven D. Cylindrical
22.6k views
0 votes
The use of a center line plus diameter symbol indicates that the part is?

A. Cubed
B. Flat
C. Uneven
D. Cylindrical

User MightySeal
by
8.7k points

1 Answer

4 votes

Answer: D. Cylindrical

Step-by-step explanation:

The use of a center line plus diameter symbol indicates that the part is Cylindrical

User Diya Li
by
8.3k points
← Prev Question Next Question →

No related questions found

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!