Register

PLEASE HELP THIS IS A TEST I WAS SUPPOSE TO DO 8 HOURS AGO. An object has a width of 1.0 in. if you were to create a 1:4 scaled drawing of this object, what would the dimensions…

PLEASE HELP THIS IS A TEST I WAS SUPPOSE TO DO 8 HOURS AGO. An object has a width of 1.0 in. if you were to create a 1:4 scaled drawing of this object, what would the dimensions…
201k views
17 votes
PLEASE HELP THIS IS A TEST I WAS SUPPOSE TO DO 8 HOURS AGO.

An object has a width of 1.0 in. if you were to create a 1:4 scaled drawing of this object, what would the dimensions of the drawing be?​

User Ayrton
by
8.3k points

1 Answer

7 votes
The only dimension you gave me is the width so I will work with that. If it’s asking for a smaller drawing than what is giving then the width will be 1/4 inch but if you’re saying the drawing is bigger then the width will be 4 inches
User Ryan Li
by
7.9k points
← Prev Question Next Question →

No related questions found

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!