Register
How do I run a transient analysis in LTspice?
80.0k views
4 votes
How do I run a transient analysis in LTspice?

User Andrea Alhena
by
7.4k points

1 Answer

1 vote

Answer:

Click "Simulate"-"Edit Simulation Cmd" in the menu bar to open the "Edit Simulation Command" screen. Select "Transient" and enter "10 m" for Stop time. You should now see ". tran 10m" at the bottom of the screen.

Step-by-step explanation:

User CaptEmulation
by
7.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.5m questions

11.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!