Register
What are testing tools in the woodwork shop?
88.0k views
1 vote
What are testing tools in the woodwork shop?

User Orr Matarasso
by
7.4k points

1 Answer

4 votes

Answer:1. Tape Measure

2. Steel Rule

3. Laser Measure

4. Folding Rule

5. Speed Square

6. Machinist Square

7. Combination Square

8. Framing Square

9. Universal Angle Guide

10. Digital Sliding T-Bevel Gauge

11. Digital Depth Gauge

12. Digital Calipers

13. The Level

14. Moisture Meter

15. Hand Plane Sole Check Gauge

Step-by-step explanation:

Mentioned above are the basic tools plus advanced technology tools.

User Hemant Kumar
by
7.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.5m questions

11.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!