Register
How often do fire extinguishers need to be inspected
119k views
3 votes
How often do fire extinguishers need to be inspected

User Aamir Shahzad
by
7.2k points

1 Answer

5 votes

Answer:

Step-by-step explanation:

Fire extinguishers need to be inspected regularly to ensure that they are in good working condition and ready for use in case of a fire emergency. The frequency of inspections depends on various factors, such as the type of fire extinguisher, the location, and the local regulations and codes.

As a general guideline:

  • Portable fire extinguishers: Monthly inspections are recommended, and annual maintenance by a certified fire extinguisher service technician is also required.
  • Fixed fire suppression systems: The frequency of inspections may vary depending on the type of system and the local codes, but annual inspections by a licensed fire protection company are typical.

It is important to note that fire extinguishers should be inspected more frequently in high-risk or high-traffic areas, such as in a commercial kitchen or near flammable materials. Employers should consult with a fire protection specialist to determine the appropriate inspection schedule for their fire extinguishers.

User Tad Harrison
by
8.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.0m questions

10.6m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!