Register

What is a relatively inexpensive way to communicate product ideas? O training marketing personnel to describe product components O drawing a simple sketch or model O building a …

What is a relatively inexpensive way to communicate product ideas? O training marketing personnel to describe product components O drawing a simple sketch or model O building a …
128k views
24 votes
What is a relatively inexpensive way to communicate product ideas?

O training marketing personnel to describe product components
O drawing a simple sketch or model
O building a complete prototype
O creating a three-dimensional version of the product using CAD software

User Pedro Almeida
by
8.8k points

1 Answer

5 votes

Answer:

B

drawing a simple sketch or model

Step-by-step explanation:

User Ijaz Ahmed
by
8.2k points
← Prev Question Next Question →

No related questions found

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!