Register
2. You should hold your fingers on the power switch when holding a plugged- in power tool. A True B. False
225k views
25 votes
2. You should hold your fingers on the power switch when holding a plugged-

in power tool.
A True
B. False

User Sam Westrick
by
8.0k points

1 Answer

5 votes
Secure work with clamps or a vise, freeing both hands to operate the tool. Avoid accidental starting. The worker should not hold a finger on the switch button while carrying a plugged-in tool. Tools should be maintained with care so it is FALSE!!
User Teoretic
by
8.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.9m questions

11.6m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!