Register
PWM input and output signals are often converted to analog voltage signals using low-pass filters. Design and simulate the following: a PWM signal source with 1 kHz base frequency and adjustable pulse-width
92.3k views
17 votes
PWM input and output signals are often converted to analog voltage signals using low-pass filters. Design and simulate the following: a PWM signal source with 1 kHz base frequency and adjustable pulse-width modulation(PWM source), an analog filter with time constant of 0.01 s. Simulate the input and output of the low pass filter for a PWM duty cycle of 25, 50, and 100%

User Pauli Nieminen
by
4.4k points

1 Answer

8 votes

Answer:

Attached below

Step-by-step explanation:

PWM signal source has 1 KHz base frequency

Analog filter : with time constant = 0.01 s

low pass transfer function =
(1)/(0.01s + 1 )

PWM duty cycle is a constant block

Attached below is the design and simulation into Simulink at 25% , 50% and 100% respectively

PWM input and output signals are often converted to analog voltage signals using low-example-1
PWM input and output signals are often converted to analog voltage signals using low-example-2
PWM input and output signals are often converted to analog voltage signals using low-example-3
PWM input and output signals are often converted to analog voltage signals using low-example-4
User Tura
by
5.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.1m questions

6.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!