Register
7. Technician A says grease is valued for its ability to stay on parts for a long time. Technician B says grease is valued for its ability to withstand high pressure. Who is correct? A. A only B. B only
471 views
18 votes
7. Technician A says grease is valued for its ability to stay on parts for a long time. Technician B says grease is valued for its ability to withstand high

pressure. Who is correct?
A. A only
B. B only
C. Both are correct.
D. Neither is correct.

User Mamoru Satoh
by
8.2k points

2 Answers

10 votes
Both are correct they both are useful
User Banjo
by
7.9k points
3 votes

Answer:

c. both are correct

Step-by-step explanation:

grease is great for high pressure applications and staying for a long time

User I Alarmed Alien
by
7.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!