Register
What Things Should you check BEFORE exporting a file to print from TinkerCAD A. check for more than one object B. is the file name correct C. Do I have any Floating Objects or Objects Not Connected D.
139k views
7 votes
What Things Should you check BEFORE exporting a file to print from TinkerCAD

A. check for more than one object
B. is the file name correct
C. Do I have any Floating Objects or Objects Not Connected
D. orientation of the model on the build plate
E. all of the above

User Natersoz
by
7.6k points

2 Answers

4 votes

Answer:

E

Step-by-step explanation:

I think All of the above because when we were using TinkerCAD we checked for all of those things

User RobertBaron
by
7.9k points
13 votes
The answers I hope this helps have a good great day
User Carolyne
by
7.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Teresa is emotionally volatile, particularly with friends and boyfriends. She is extremely dramatic about even the smallest disappointments and is sexually and behaviorally very impulsive. Teresa would
Link Copied!