Register
A 7.80 in. diameter shaft contains a 0.900 in. deep U-shaped groove that has a 0.60 in. radius at the bottom of the groove. The maximum shear stress in the shaft must be limited to 6000 psi. If the shaft
107k views
3 votes
A 7.80 in. diameter shaft contains a 0.900 in. deep U-shaped groove that has a 0.60 in. radius at the bottom of the groove. The maximum shear stress in the shaft must be limited to 6000 psi. If the shaft rotates at a constant angular speed of 5.0 Hz, determine the maximum power that may be delivered by the shaft.

User Mtjhax
by
5.4k points

1 Answer

2 votes

Answer:

The torque is the shear strees multiplied by radius. Radius = 50mm. We'll also have to convert mpa to Newton/mm^2. 1 mpa= 1 N/mm^2. Sowe are good to go. I. e we also have 60N/mm^2. Multiplying both gives 60 N/mm^2 * 50mm = 300N

Step-by-step explanation:

User Ivan Correa
by
5.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.6m questions

8.7m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!