Register

Engineers are designing a ceramic component for a jet engine. The ceramic has a fracture toughness of 8 MPa m^1/2. The ceramic is subjected to a maximum tensile stress of 500 MP…

Engineers are designing a ceramic component for a jet engine. The ceramic has a fracture toughness of 8 MPa m^1/2. The ceramic is subjected to a maximum tensile stress of 500 MP…
231k views
4 votes
Engineers are designing a ceramic component for a jet engine. The ceramic has a fracture toughness of 8 MPa m^1/2. The ceramic is subjected to a maximum tensile stress of 500 MPa. Calculate the maximum size of surface flaws that the part can have.

User BeeFriedman
by
8.0k points

1 Answer

0 votes
Engineers always have a design to ceramic components at 8mpa
User Nevin
by
7.9k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!