Register
Tech A says that a cylinder leakage test is performed on a cylinder with low compression to determine the severity of the leak and where it is located. Tech B says that most manufacturers consider up to
223k views
2 votes
Tech A says that a cylinder leakage test is performed on a cylinder with low compression to determine the severity of the leak and where it is located. Tech B says that most manufacturers consider up to 50% cylinder leakage acceptable. Who is correct?

User Adeynack
by
4.6k points

1 Answer

4 votes
Tech A djjdjdndnndndbdbx
User ThePravinDeshmukh
by
6.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.2m questions

8.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Where are all the controls on most circuits?
Link Copied!