Register

A tensile load of 6.9 kN is applied on a copper rod with diameter of 12 mm. (a) What is the maximum normal stress in the rod? (b) What is the maximum shear stress in the rod?

A tensile load of 6.9 kN is applied on a copper rod with diameter of 12 mm. (a) What is the maximum normal stress in the rod? (b) What is the maximum shear stress in the rod?
188k views
0 votes
A tensile load of 6.9 kN is applied on a copper rod with diameter of 12 mm. (a) What is the maximum normal stress in the rod? (b) What is the maximum shear stress in the rod?

User Condit
by
7.8k points

1 Answer

6 votes

Answer:

a) 61 MPa

b) 0 MPa

Step-by-step explanation:

See it in the pic.

A tensile load of 6.9 kN is applied on a copper rod with diameter of 12 mm. (a) What-example-1
User Chinna
by
8.1k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!