Register
Which is more detrimental to the tool life, a higher depth of cut or a higher cutting velocity? Why?
58.4k views
3 votes
Which is more detrimental to the tool life, a higher depth of cut or a higher cutting velocity? Why?

User Muthurathinam
by
5.6k points

1 Answer

3 votes

Answer:

Cutting velocity.

Step-by-step explanation:

Velocity of cutting affects more as compare to the depth of cut to life of tool.

As we know that tool life equation


VT^n=C

Where T is the tool life and V is the tool cutting speed and C is the constant.

So from we can say that when cutting velocity increase then tool life will decrease and vice versa.

The life of tool is more important during cutting action .The life of tool is less and then will reduce the production and leads to face difficulty .

User Bulkin
by
5.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.3m questions

6.9m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!