Register
Single point cutting tool removes material from a rotating work piece to generate a cylinder is called • Facing Tuming • Both 1 & 2 • None of them
19.6k views
3 votes
Single point cutting tool removes material from a rotating work piece to generate a cylinder is called • Facing Tuming • Both 1 & 2 • None of them

User Oto
by
6.2k points

1 Answer

5 votes

Answer:Turning

Explanation: Turning is the process in which the work piece is subjected to machining so that excess part is removed with the help of rotation by turning machine or lathe machine.The cutter tool is used for cutting the excess of the work piece and it is mostly single-pointed so that give accurate removal of the excess of work piece.At times , according to the requirement multi-pointed tool is also used Therefore, the correct option is turning.

User Nhu Nguyen
by
5.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.9m questions

7.7m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!