Register
Poor resistance to scoring in journal bearings is called: a) Fatigue resistance b) cohesive wear c) adhesive wear d) abrasive wear
191k views
4 votes
Poor resistance to scoring in journal bearings is called: a) Fatigue resistance b) cohesive wear c) adhesive wear d) abrasive wear

User TheNoob
by
7.7k points

1 Answer

3 votes

Answer:

b) Cohesive wear.

Step-by-step explanation:

The question has some engineering subjects as Fatigue Mechanical, surface engineering, bearings design and material engineering.

According the definition of cohesive wear is the damage, gradual deformation of material at solid surfaces.

User Pervez
by
7.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.5m questions

11.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!