Register
Which of the following is not an example of heat generation? a)- Exothermic chemical reaction in a solid b)- Endothermic Chemical Reactions in a solid c)- Nuclear reaction in nuclear fuel rods d)- Electric
132k views
1 vote
Which of the following is not an example of heat generation? a)- Exothermic chemical reaction in a solid b)- Endothermic Chemical Reactions in a solid c)- Nuclear reaction in nuclear fuel rods d)- Electric resistance heater

User Hong Wei
by
9.0k points

1 Answer

4 votes

Answer:

b) Endothermic Chemical Reactions in a solid

Step-by-step explanation:

Endothermic reactions consume energy, which will result in a cooler solid when the reaction finishes.

User Mikhail Sidorov
by
8.5k points
← Prev Question Next Question →

Related questions

User Shoshannah
asked Oct 8, 2021 175k views
Nuclear reactors use fuel rods to heat water and generate steam. Is this process endothermic or exothermic?
Shoshannah asked Oct 8, 2021
by Shoshannah
8.3k points
2 answers
5 votes
175k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
Teresa is emotionally volatile, particularly with friends and boyfriends. She is extremely dramatic about even the smallest disappointments and is sexually and behaviorally very impulsive. Teresa would
A 200 g projectile is fired with a velocity of 900 m/s toward the center of a 15 kg wooden block which rests on a rough surface. If the projectile penetrates and emerges from the back at a velocity of
The pressure at any point in a static fluid depends only on the Select one a)- depth, surface pressure, and specific weight. b)- specific weight. c)- surface pressure and depth. d)- depth and container
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
Link Copied!