Register
There are a number of requirements that employers must do to protect their workers from caught-in or between hazards. Which of these is required if the worker's body, hands or clothing may come into contact
227k views
0 votes
There are a number of requirements that employers must do to protect their workers from caught-in or

between hazards. Which of these is required if the worker's body, hands or clothing may come into contact
with moving parts?
O A Prevent workers from being pinned under heavy equipment
O B. Provide guards on power tools and other equipment with moving parts
O C. Provide protection to workers in an excavation or trench
OD. Protect workers from collapsed scaffolding

User Visionscaper
by
4.7k points

1 Answer

4 votes

Answer:

B.Provide guards on power tools and other equipment with moving parts

Step-by-step explanation:

A guard/ safeguard is a machine feature that is on/around an engineering equipment which can prevent the contact of a user with hazardous parts of the machines such as point of operation and rotating parts.The guard can be on power tools to enable an alternataive ways of switching off the equipment when a danger scenario occurs.When using a tool/equipment, safeguards must be on/active.

User Zstack
by
5.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.3m questions

6.9m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!