Register
Orthographic drawings are used to express ideas that are more complicated. Explain the purpose of the different views and the importance of view alignment
210k views
19 votes
Orthographic drawings are used to express ideas that are more complicated. Explain the purpose of the different views and the importance of view alignment

User Mina Samir
by
6.0k points

2 Answers

3 votes

Answer:

Step-by-step explanation:

Orthographic drawings represent 3D objects using 2D projections.

If you wanted to show what a car looked like and were limited to 2D drawings, you might show a sketch of the front of the car, the side of the car, and the back of the car. These orthographic projects show all the detail of the cars different "sides" effectetly using 2D drawings.

These projections should be aligned such that features of the car can be cross-referenced between different projections.

User Nohayeye
by
5.5k points
8 votes

Answer:

Step-by-step explanation:

Orthographic drawings represent 3D objects using 2D projections.

If you wanted to show what a car looked like and were limited to 2D drawings, you might show a sketch of the front of the car, the side of the car, and the back of the car. These orthographic projects show all the detail of the cars different "sides" effectetly using 2D drawings.

These projections should be aligned such that features of the car can be cross-referenced between different projections.

User Tezzo
by
6.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.5m questions

8.6m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!