Register
Which of the following identifies how an engineer includes interior designs? O An internal view is used by scalinga drawing to the exact dimensions. OA crisscross replica is made of the design prototype
4.7k views
2 votes
Which of the following identifies how an engineer includes interior designs?

O An internal view is used by scalinga drawing to the exact dimensions.
OA crisscross replica is made of the design prototype to show the interior view.
O An internal design is not necessary until a machinist has created the design.
OAsketch is included to show interior designs using a technique called sectioning.

User Sven Hecht
by
8.4k points

1 Answer

8 votes

Answer:

i know this one well hypotheticly what if i where to say it was 0 b

User Ayman Safadi
by
8.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.3m questions

12.0m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!