Question

Which step in the construction of copying a line segment ensures that the new line segment has

the same length as the original line segment?

Answer 1

Here are the steps I think you probably will go through.

1. Draw a line that is longer than the segment but shorter than the width of the page.

1a. Make sure this line is at least 1/2 inch from the left hand side.

2. Use a compass to measure the length of the original segment. Never use a ruler. Rulers do not exist in pure geometry.

3. Measure out the distance on the line you just drew with the compass. One end is on the left hand edge and the other end (the pencil end) is marking the segment so it is the same length as the compass. You are done.

The key step either two or three.

Answer 2

Answer: Step Two

Draw a line that is longer than the segment but not wider than the page's width. This line should be at least 1/2 inch away from the left-hand side. After that, measure the length of the original segment with a compass. Following that step, measure the distance along the compass line. (One end is on the left edge, while the other (the pencil end) is used to mark the section so that it is the same length as the compass) Step two is the most important step in the process of copying a line segment to ensure that the new line segment is the same length as the original.

Explanation:

I took the test