Register
wide 100A service equipment panelboard is installed on the wall in the basement of a building. The Code requires that a space of atleast _________ inches in width be maintained about this panelboard.
149k views
2 votes
wide 100A service equipment panelboard is installed on the wall in the basement of a building. The Code requires that a space of atleast _________ inches in width be maintained about this panelboard.

User Sachin I
by
5.4k points

1 Answer

0 votes

Answer:

30 inches.

Step-by-step explanation:

The National Electrical Code (NEC) can be defined as a regional standard adopted by various municipalities and state so as to ensure the safe installation of electrical wiring and machineries (equipments) in the United States of America. Thus, the main purpose of the National Electrical Code (NEC) is to enable a safe and effective electrical practices.

A 14-inch wide 100-ampere service equipment panelboard is installed on the wall in the basement of a building. The National Electrical Code (NEC) requires that a space of at least 30 inches in width be maintained about this panelboard.

This ultimately implies that, according to the National Electrical Code (NEC), the minimum number of space required for a 14-inch wide 100-ampere service equipment panelboard is 30 inches.

User Big Bad Baerni
by
4.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.7m questions

7.4m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!