Register

Which of the following is NOT a common problem or mistake with blueprints? A.Illegible writing B. Using the most current blueprints C.Inconsistent scales D.Misinterpretation of …

Which of the following is NOT a common problem or mistake with blueprints? A.Illegible writing B. Using the most current blueprints C.Inconsistent scales D.Misinterpretation of …
152k views
0 votes
Which of the following is NOT a common problem or mistake with blueprints?

A.Illegible writing

B. Using the most current blueprints

C.Inconsistent scales

D.Misinterpretation of drawings

User Plspl
by
8.4k points

1 Answer

0 votes

Answer:

illegible.writng

Step-by-step explanation:

am I right

User Crhodes
by
7.5k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!