Register

If a base metal is not hot enough when braze welding, the filler metal will bead and roll off of the base metal as water does on a greasy surface." O True O False​

If a base metal is not hot enough when braze welding, the filler metal will bead and roll off of the base metal as water does on a greasy surface." O True O False​
31.4k views
2 votes
If a base metal is not hot enough when braze welding, the filler metal will bead and roll off of the base metal as water does on a greasy surface." O True O False​

User Vini
by
8.7k points

1 Answer

1 vote
true hope this helps
User Trevin Corkery
by
7.9k points
← Prev Question Next Question →

Related questions

User Fourj
asked Dec 13, 2024 169k views
When braze welding, if the metal is not hot enough, what happens to the filler metal?
Fourj asked Dec 13, 2024
by Fourj
7.1k points
1 answer
3 votes
169k views
User Pratik Bhoir
asked Mar 13, 2024 206k views
When braze welding, what flame do you use to tin the weld area?
Pratik Bhoir asked Mar 13, 2024
by Pratik Bhoir
7.9k points
1 answer
2 votes
206k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!