Register
A wedge would be best described as A wheel and axle used to cTeate a rotary motion A lever arm fixed to a shaft A triangle shaped tool that functions as an inclined plane A rectangular shaped tool that
215k views
4 votes
A wedge would be best described as

A wheel and axle used to cTeate a rotary motion
A lever arm fixed to a shaft
A triangle shaped tool that functions as an inclined plane
A rectangular shaped tool that functions as a pulley

User Dumbmatter
by
8.2k points

2 Answers

4 votes

Answer:

A rectangular shaped tool that functions as a pulley.

Step-by-step explanation:

i beleive

User Basvo
by
7.9k points
4 votes
The answer is

C. A triangle shaped tool that functions as an incline ld plane
User Adam Liss
by
8.5k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Where are all the controls on most circuits?
Link Copied!