Register
Which design activity is part of the design for manufacturability (DFM) methodology? Aavold parts that are mirror Images B. establish guidelines on the go с. some asymmetrical parts are acceptable D. maximize
231k views
0 votes
Which design activity is part of the design for manufacturability (DFM) methodology?

Aavold parts that are mirror Images
B. establish guidelines on the go
с. some asymmetrical parts are acceptable
D.
maximize utilization of setup time

User QWERTYL
by
8.0k points

1 Answer

4 votes

Answer:

D would be correct because it maximizes it.

User Fbarber
by
8.2k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!