Register
Mechanically, a is the possible cause of cylinder drift. A Blocked cylinder port B Physical obstruction C Bent rod D Worn piston seal
205k views
1 vote
Mechanically, a

is the possible cause of cylinder drift.
A Blocked cylinder port
B Physical obstruction
C Bent rod
D Worn piston seal

User Wim Ten Brink
by
8.4k points

2 Answers

5 votes
I THINK THE ANSWER IS D WORM PISTON SEAL BUT I AM NOT SURE OK BYE
User Galaxis
by
7.9k points
4 votes
I’m not sure if it correct but did some research I think answer D is correct but not sure if it’s correct please tell me if I was wrong or right. :)
User ThiefMaster
by
8.2k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
What claim do ghost hunters make about energy-detecting devices? They can determine how many spirits are in one location. They can produce sounds that may be confused with ghosts. They can sense the presence
Homes may be heated by pumping hot water through radiators. What mass of water (in g) will provide the same amount of heat when cooled from 90.7 to 39.4°C, as the heat provided when 182 g of steam is cooled
If a host system is 80% efficient, the minimum horsepower rating of the motor should be ? if the hoist is to provide 20,000 ft-lb/s. a) 45.45hp b) 23,530hp c) 36.36hp d) 42.78hp
Link Copied!