Recent questions in Engineering

Question

How is the required CFM (Cubic Feet per Minute) for an A/C system determined? a. By the size of the HVAC unit b. By the color of the ductwork c. By the number of windows in the building d. Varies depending

Klugerama asked Dec 7, 2024

by Klugerama

8.6k points

1 answer

3 votes

34.2k views

Note 3 safety precautions when using a horizontal band saw.

TheWommies asked Dec 7, 2024

by TheWommies

8.1k points

1 answer

5 votes

208k views

What is the recommended exposure time for a Nonel detonator assembly in n explosive that uses fuel oil as a component?

Bruno Lopes asked Dec 7, 2024

by Bruno Lopes

8.0k points

1 answer

1 vote

101k views

When creating a Regional Command Post composed of more than one component, who will ensure all coordination requirements listed in AFI 90-1001 are met prior to implementation?

Yannisf asked Dec 7, 2024

by Yannisf

7.8k points

1 answer

4 votes

140k views

Consider a buddy system with 5 different hole sizes (2⁰ through 2⁴). (a) Assume a sequence of requests of the following sizes is made: 2, 1, 2, 4. Show the memory layout, including the header array H,

Umair Durrani asked Dec 7, 2024

by Umair Durrani

8.5k points

1 answer

4 votes

11.2k views

Portion of drape that falls below ___________ is considered contaminated A) The waist level B) The chest level C) The knee level D) The table level

Dmitreyg asked Dec 7, 2024

by Dmitreyg

8.2k points

1 answer

4 votes

229k views

By properly spacing decking, some allowance for wood movement, drainage, and drying is provided. What is the minimum spacing of deck boards? a. 1/8 inch b. 1/4 inch c. 1/2 inch d. 3/4 inch

Nicogpt asked Dec 7, 2024

by Nicogpt

8.3k points

1 answer

3 votes

43.1k views

How do you perform negative unity feedback for the overall system transfer function? a) 'feedback(sys, -1)' function b) 'unity_feedback()' command c) 'negative_feedback()' function d) Enter 'neg_feedback(sys)'

Kemar asked Dec 7, 2024

by Kemar

8.3k points

1 answer

5 votes

183k views

FLIGHT CONTROL LAWS: What functions does the rudder perform in normal law?

Fayette asked Dec 7, 2024

by Fayette

7.8k points

1 answer

4 votes

104k views

Commanders will ensure that IET Trainees/Soldiers departing BCT for AIT have a serviceable copy of both (Select that all Apply) A) TP 600-4 B) STP 21-1 SMCT C) TR 350-6 D) DA 31

Amater asked Dec 7, 2024

by Amater

8.3k points

1 answer

3 votes

219k views

What determines the coarseness of a power band saw blade?

Coreyspitzer asked Dec 7, 2024

by Coreyspitzer

8.1k points

1 answer

5 votes

173k views

To lessen the movement caused by barrel whip, try using a ____________ barrel instead. A) Shorter B) Heavier C) Longer D) Thinner

Levi Fuller asked Dec 7, 2024

by Levi Fuller

7.7k points

1 answer

1 vote

112k views

Most rear-end collisions are caused by vehicle operators following another vehicle more closely than is reasonable and prudent. t f

CaptRespect asked Dec 7, 2024

by CaptRespect

7.8k points

1 answer

1 vote

122k views

Which part in the drum brake system expands outward against the drum to stop a vehicle when brakes are applied? A pads B shoes C bushings D springs

Learningtech asked Dec 7, 2024

by Learningtech

8.1k points

1 answer

0 votes

79.6k views

What PPE should you use for droplet-based transmissions?

ALearner asked Dec 7, 2024

by ALearner

8.8k points

1 answer

5 votes

89.9k views

A grease trap works on the principle that: Select one: a. greases with low relative density will float on the surface of water. b. greases and water cannot mix. c. slow moving fluid streams allow the mixtures

Ankit Bhatia asked Dec 7, 2024

by Ankit Bhatia

8.7k points

1 answer

2 votes

214k views

Design two equally sized rectangular settling basins for treating a total flow rate of 2.5 MGD using an overflow rate of 500 gpd/ft2 and a detention time of four hours. Use a length : width ratio of 4

Dan Lorenc asked Dec 7, 2024

by Dan Lorenc

7.6k points

1 answer

0 votes

78.9k views

When parking at the roadside park at an angle of __ to __ degrees with the ___ wheel touching the curb

Svfat asked Dec 7, 2024

by Svfat

8.8k points

1 answer

4 votes

25.4k views

During construction, the architect realizes that an incorrect finish tag was used on one of the bathroom elevations. The project manager would like to issue a clarification to the contractor prior to the

Gavin Gilmour asked Dec 7, 2024

by Gavin Gilmour

8.1k points

1 answer

4 votes

180k views

A materials response to applied force depends on its load bearing characteristics, what are the 4 characteristics?

Neberaa asked Dec 7, 2024

by Neberaa

7.9k points

1 answer

4 votes

144k views

Page:

« prev
1
...
167
168
169
170
171
172
173
...
1000
...
next »

Ask a Question

Recent questions in Engineering

Other Questions