Recent questions in Engineering

Question

Name 3 variables that affect the quality of a humidifier's performance. a) Temperature b) Surface area c) Time of contact d) Altitude

Trydis asked Dec 12, 2024

by Trydis

7.5k points

1 answer

3 votes

69.9k views

What is Volume II in the NAVSUP P-485? A) General Shipboard Material B) Maintenance Procedures C) Safety and Occupational Health D) None of the above

Aleyam asked Dec 12, 2024

by Aleyam

7.9k points

1 answer

1 vote

121k views

Let for what value of is in the plane spanned by and _____________.

Tesia asked Dec 12, 2024

by Tesia

8.4k points

1 answer

3 votes

172k views

What does a Natural Sign indicate? 1) To play the note without any alteration 2) To raise the pitch of the note by a half step 3) To lower the pitch of the note by a half step 4) To cancel the previous

Tess asked Dec 12, 2024

by Tess

7.8k points

1 answer

2 votes

123k views

Discuss the importance of building security into software. How you can you evade associated risks with releasing insure software?

Beren asked Dec 12, 2024

by Beren

8.0k points

1 answer

1 vote

141k views

The reading of the black hand of the duplex air gauge when operating normally should be approximately _______ lbs (28-100)

R T asked Dec 12, 2024

by R T

8.4k points

1 answer

5 votes

186k views

What is an elevation focus of 0.5cm via a stand off pad optimal for?

DotNetInfo asked Dec 12, 2024

by DotNetInfo

8.6k points

1 answer

2 votes

100k views

Either prove that the wff is a valid argument or give an interpretation in which it is false. (∃x)[R(x)⋁S(x)]→(∃x)R(x)⋁(∃x)S(x)

Pdolinaj asked Dec 12, 2024

by Pdolinaj

8.6k points

1 answer

0 votes

23.7k views

An article in Fortune (September 21, 1992) claimed that around one-half of all engineers continue academic studies beyond the B.S. degree, ultimately receiving either an M.S. or a Ph.D. degree. Data from

Vincent Russo asked Dec 12, 2024

by Vincent Russo

8.7k points

1 answer

5 votes

182k views

What should you do if you come across a snow covered roof? a. Remove the snow and inspect as usual b. Note the snow and inspect as usual c. Note the snow and lack of visibility and access d. Say nothing

Sdayal asked Dec 12, 2024

by Sdayal

7.7k points

1 answer

3 votes

216k views

Why should a vessel operator keep a sharp look out ?

Robasta asked Dec 12, 2024

by Robasta

8.7k points

1 answer

0 votes

21.7k views

What is one of the signals provided by the Alpha AI?

Oz asked Dec 12, 2024

by Oz

7.8k points

1 answer

5 votes

170k views

The driver must be able to see a warning that is given before air pressure in the service air tanks falls below: A) 80 psi B) 40 psi C) 20 psi D) 60 psi

Kilo asked Dec 12, 2024

by Kilo

8.4k points

1 answer

3 votes

54.8k views

Which publication requires infrequent corrections? A. List of Lights B. Coast Pilot C. Sailing Directions (Planning Guide) D. Radio Navigational Aids

Mifeng asked Dec 12, 2024

by Mifeng

8.0k points

1 answer

4 votes

229k views

What should Be removed to check the fluid level in a differential? A) dipstick B) driveshaft C) fill plug D) spark plug

Puri asked Dec 12, 2024

by Puri

7.8k points

1 answer

5 votes

142k views

Why is threading more sanitary than waxing?

Ligos asked Dec 12, 2024

by Ligos

8.2k points

1 answer

0 votes

163k views

Speed at which rotation from three-point attitude to takeoff attitude is initiated. Rotation speed is always equal to or greater than Air Minimum Control Speed (VMCA) and less than Tire Limit Speed.

Wp Student asked Dec 12, 2024

by Wp Student

9.0k points

1 answer

5 votes

93.7k views

Pass on the left side. Passing on the right is allowed only under the following conditions: a) When the vehicle ahead is making a left turn and there is sufficient room b) When the vehicle ahead is going

Dazzafact asked Dec 12, 2024

by Dazzafact

8.7k points

1 answer

3 votes

120k views

A gap or void two inches (2") or more in its least dimension in a floor, roof, or other walking/working surface is known as: Option 1. Hole Option 2. Opening Option 3. Gap Option 4. Void

Suvethan Nantha asked Dec 12, 2024

by Suvethan Nantha

8.0k points

1 answer

4 votes

139k views

What does the "X" stand for in a plywood grade CDX?

Mbogh asked Dec 12, 2024

by Mbogh

7.1k points

1 answer

3 votes

115k views

Page:

« prev
1
...
124
125
126
127
128
129
130
...
1000
...
next »

Ask a Question

Recent questions in Engineering

Other Questions