Register

What type of drawing would civil engineers use if they needed to show an object at 45° angles? isometric drawing perspective drawing orthographic drawing oblique drawing

What type of drawing would civil engineers use if they needed to show an object at 45° angles? isometric drawing perspective drawing orthographic drawing oblique drawing
86.9k views
4 votes
What type of drawing would civil engineers use if they needed to show an

object at 45° angles?

isometric drawing
perspective drawing
orthographic drawing
oblique drawing

User Reagankm
by
8.4k points

1 Answer

4 votes

Answer:

I would say an Oblique drawing.

Step-by-step explanation:

An oblique drawing uses 45 degree angles.

User Asaf Manassen
by
9.0k points
← Prev Question Next Question →

Related questions

User Ocos
asked Dec 18, 2023 148k views
What method of drawing is produced in two dimensions? A. isometric B. oblique C. orthographic D. perspective ​
Ocos asked Dec 18, 2023
by Ocos
7.4k points
2 answers
2 votes
148k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
Link Copied!