Register
A hot plate with a temperature of 60 C, 50 triangular profile needle wings of length (54 mm), diameter 10 mm (k = 204W / mK) will be added and cooled. Ambient temperature is 20 C and heat transfer coefficient
123k views
5 votes
A hot plate with a temperature of 60 C, 50 triangular profile needle wings of length (54 mm), diameter 10 mm (k = 204W / mK) will be added and cooled. Ambient temperature is 20 C and heat transfer coefficient is 20 Since it is W / m2K; a-) Wing efficiency, b-) Total heat transfer rate (W) from the wings, c-) Calculate the effectiveness of a wing.

User Malbarbo
by
5.3k points

1 Answer

1 vote

Complete question is;

A hot plate with a temperature of 60 °C will be cooled by adding 50 triangular profile needle blades (k = 204 W/m.K) with a length of 54 mm and diameter 10 mm. According to the ambient temperature 20 °C and the heat transfer coefficient on the surface 20 W/m².K. Calculate,

a-) Wing efficiency

b-) Total heat transfer rate (W) from the wings,

c-) Calculate the effectiveness of a wing.

Answer:

A) Efficiency = 96.05 %

B) Total heat transfer rate = 166.68 W/m

C) Wing Effectiveness = 10.42

Step-by-step explanation:

Please find attached explanation for all the answers given.

A hot plate with a temperature of 60 C, 50 triangular profile needle wings of length-example-1
A hot plate with a temperature of 60 C, 50 triangular profile needle wings of length-example-2
A hot plate with a temperature of 60 C, 50 triangular profile needle wings of length-example-3
User Ameba Spugnosa
by
5.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.3m questions

6.9m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!