Register

A 57 tooth spur gear is mated with a 23 tooth pinion. Get the reason contact, with a 4mm module and a 20 ° pressure angle.

A 57 tooth spur gear is mated with a 23 tooth pinion. Get the reason contact, with a 4mm module and a 20 ° pressure angle.
107k views
4 votes
A 57 tooth spur gear is mated with a 23 tooth pinion. Get the reason contact, with a 4mm module and a 20 ° pressure angle.

User Gloomcore
by
9.1k points

1 Answer

1 vote

Answer:

...........i don't no ok i don't no this question

User Frank Allenby
by
7.8k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
Link Copied!