Register

Guest Given e = 7.07 sin wt E = 5V 0degree R= vr 1k ohm L=Vl 20 mH a.Plot Zt and Thetat versus frequency for a frequency range of zero to 20kHz b.Plot Vl versus frequency for th…

Guest Given e = 7.07 sin wt E = 5V 0degree R= vr 1k ohm L=Vl 20 mH a.Plot Zt and Thetat versus frequency for a frequency range of zero to 20kHz b.Plot Vl versus frequency for th…
138k views
3 votes
Guest

Given e = 7.07 sin wt
E = 5V 0degree
R= vr 1k ohm
L=Vl 20 mH


a.Plot Zt and Thetat versus frequency for a frequency range of zero to 20kHz
b.Plot Vl versus frequency for the frequency range of part (a).
c.Plot thetat versus frequency for the frequency range of part(a).
d.Plot Vr versus frequency for the frequency range of part (a).

User Ximena
by
9.4k points

1 Answer

3 votes

Answer:

The given values of e, E, R, and L are not sufficient to calculate the impedance and phase angle as a function of frequency. Could you please provide more information such as the circuit diagram or the values of capacitance and frequency, if applicable? Once I have the necessary information, I can assist you in generating the requested plots.

Step-by-step explanation:

User Strikers
by
8.4k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!