Final answer:
Before wetting a non-particle microdermabrasion device, it should be dry wiped using a clean cloth to remove surface debris, then rinsed with lukewarm water while ensuring proper flow direction from wrist to fingertips, and dried thoroughly.
Step-by-step explanation:
Cleaning a Non-Particle Microdermabrasion Device
Before wetting a non-particle microdermabrasion device, it is important to first thoroughly rub the device with a dry cloth. This step is crucial to remove any debris that might be present on the device's surface. After the initial dry wiping, proceed to open the faucet just enough to allow a smooth stream of water for rinsing. Make certain that the water temperature is lukewarm, as very hot or very cold water should be avoided to prevent damaging the device.
When performing these cleaning steps, use only alcohol-free products and avoid harsh astringents or exfoliants that could irritate the skin. Upon rinsing, ensure that the wastewater flows from the wrist to the fingertips to discourage any potential contamination from moving up the arms. After rinsing, the device should be dried thoroughly, and all used towels or cleaning materials should be properly disposed of to maintain hygiene standards.