Register
This person is responsible for the installation, testing, and support of the product (process) once its engineering is complete. a) Project Manager b) Design Engineer c) Quality Control Inspector d) Installation
51.4k views
4 votes
This person is responsible for the installation, testing, and support of the product (process) once its engineering is complete.

a) Project Manager
b) Design Engineer
c) Quality Control Inspector
d) Installation Engineer

User Demotry
by
7.6k points

1 Answer

1 vote

Final answer:

An installation engineer is responsible for the installation, testing, and support of the product/process once its engineering is complete.

Step-by-step explanation:

The person responsible for the installation, testing, and support of the product (process) once its engineering is complete is an Installation Engineer.

An Installation Engineer works closely with design engineering to coordinate the release of new products. They estimate manufacturing costs, determine time standards, and make recommendations for tooling and process requirements. They also maintain records and reporting systems for manufacturing operations.

An Installation Engineer uses a logical, systematic approach to problem-solving, communicates effectively through documentation and presentation, and follows through on tasks to completion.

User AlexKoren
by
7.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.1m questions

11.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!