Question

Select all that apply.

Before collecting data with the "Faraday's Law Pendulum," the important things to check are:

A. The voltage probe is not being affected by any potential drop or parasitic capacitance from other components in the circuit
B. The cables and connectors used in the setup are properly shielded and grounded
C. The rotary motion sensor is connected to channel 1 & 2, (yellow connected to channel 1)
D. The amplifier and filter settings of the PASCO box are appropriate for the input signal
E. The detector coil is connected securely to the rotary motion sensor and swings freely
F. At a dead hang, the center of the detector coil is aligned with the center of the magnet
G. The voltage probe connected to channel D of the PASCO box is properly calibrated for the range of the 2000-turn detector coil
H. The voltage probe connected to channel D of the PASCO box is connected to the 2000 turn detector coil, with the red cable above the black cable

Answer 1

To obtain accurate data with the 'Faraday's Law Pendulum,' it is important to check the voltage probe for interference, ensure cables are shielded and grounded, that sensors and probes are correctly connected, and that the settings on the PASCO box are adjusted appropriately for the signal.

Step-by-step explanation:

Before collecting data with the "Faraday's Law Pendulum," it is crucial to check several things to ensure accurate results. The important things to check are:

• The voltage probe is not being affected by any potential drop or parasitic capacitance from other components in the circuit.
• The cables and connectors used in the setup are properly shielded and grounded.
• The rotary motion sensor is connected to channel 1 & 2, with the yellow connected to channel 1.
• The amplifier and filter settings of the PASCO box are appropriate for the input signal.
• The detector coil is connected securely to the rotary motion sensor and swings freely.
• At a dead hang, the center of the detector coil is aligned with the center of the magnet.
• The voltage probe connected to channel D of the PASCO box is properly calibrated for the range of the 2000-turn detector coil.
• The voltage probe connected to channel D of the PASCO box is connected to the 2000 turn detector coil, with the red cable above the black cable.

Ensuring all these are checked and in place, the Faraday's Law Pendulum experiment should run smoothly and yield accurate data.